Working with Custom Printed Decals

1. Prepare the Surface:

   • Clean the area where you will apply the decal to ensure it’s free of dust, grease, and moisture. Use a mild cleaner and allow it to dry completely.

2. Trim the Decal:

   • Carefully cut out the decal, leaving a small border if necessary. Use sharp scissors or a craft knife for clean edges.

3. Position the Decal:

   • Place the decal on the surface without removing the backing. Use tape to hold it in place if needed, and adjust for proper alignment.

4. Apply Transfer Tape (if applicable):

   • If your decal is intricate, place transfer tape over the decal to hold it together. Burnish it down with a squeegee.

5. Peel and Stick:

   • Slowly peel off the backing from the decal. Start applying from one edge and gently press it onto the surface, smoothing it out with a squeegee or your fingers to remove air bubbles.

6. Final Touches:

   • Once applied, use a soft cloth to press down on the decal and ensure it adheres well. If using transfer tape, carefully peel it away, starting from one corner.

7. Seal (optional):

   • For added durability, consider applying a clear coat over the decal once it’s set. Ensure the decal is fully dry before sealing.

Tips:

• Test the decal on a small area first to check adhesion.
• If applying to a curved surface, consider using a heat gun to make the decal more pliable.

Following these steps will help you successfully apply custom printed decals for a professional finish!